Untreue Abfall Tun filament stuck in tube einzig und allein Fertigkeit Schlittschuh
Filament stuck and not able to remove PFTE Tube – Assembly and first prints troubleshooting – Prusa3D Forum
Filament stuck in tube – Hardware, firmware and software help – Prusa3D Forum
Filament stuck, nozzle dirty, PTFE tube broke... – Hardware, firmware and software help – Prusa3D Forum
Please help. I have a piece of filament stuck in the tube(1). The tube got deformed, so the new filament does not go further. (2). I wanted to cut off the tube,
creality ender 3 - How to get stuck filament out of this direct drive extruder? - 3D Printing Stack Exchange
Filament failed to unload (MINI/MINI+) | Prusa Knowledge Base
How to Remove Stuck Filament from PTFE Tubing – Clever Creations
I didn't seat my bowden tube properly in my hotend, and now there is a clump of filament stuck in the heatsink part of the hotend, how do I fix this? :
My filament is stuck in the tube between the nozzle and the extruder and I cannot figure out how to remove it. Any help Reddit? : r/ender3
PLA stuck in Bowden Tube – Technical Support – Robox® Community
Filament stuck in PTFE tube between extruder and filament sensor – Hardware, firmware and software help – Prusa3D Forum
Removing broken PVA from the Material Station
Filament stuck in first part of PTFE tube on Prusa mini + : r/prusa3d